SNF has developed specific equipment to deal with all challenges faced in polymer applications, in order to guarantee the most cost-effective solutions, while paying close attention to reducing environmental impact.
FLOQUIP POLYMER INJECTION UNIT (PIU)
SNF has developed pre-designed and standardized modular solutions, enabling injection of polymers into wells at specified viscosities and flowrates. These modular PIU (Polymer Injection Unit) systems consist of 40 ft. HC standard sea containers for easy transport. They are assembled together, integrating all of the required equipment for polymer injection and dissolution.
Modular injection systems can be connected to existing water injection lines, without the need to develop new infrastructure. These units allow for quick installation and start-up.
Modular systems enable incremental development from pilot to full-field solutions with limited and controlled risk, thereby reducing costs and delivery lead times.

POLYMER SOLUTION PREPARATION
The PIU relies on the following dissolution principle for polymers: Powder-grade polymer coming from a storage tank is proportionally mixed with water to create a polymer solution, using a patented FLOQUIPPSU (Polymer Slicing Unit). After hydration and maturation of the polymer solution is complete, it is then diluted and injected without filtration into wells, in accordance with injection rate and pressure guidelines. Nitrogen blanketing is used to preserve the polymer during the dissolution process.

POLYMER INJECTION UNIT CAPACITIES
SNF offers several models of the Polymer Injection Unit (PIU) to dissolve varying quantities of polymer utilizing our FLOQUIPPolymer Slicing Unit (PSU) technology.
Typical PIU models, primary design purposes, and capacities are outlined below.
Our FLOQUIPPIUC model is the most compact injection unit available (integrated in one 40 ft. container). It was specifically designed to minimize overall equipment size and footprint in the field.
Model | Purpose | Flow Rates | Dry Polymer |
---|---|---|---|
FLOQUIP™ PIUC | Injectivity test / Single well tracer test | 6,000 bpd @ 1,500 ppm | 1.4 MT / Day |
FLOQUIP™ PIU 100 | Pilot, small injection rates | 10,000 bpd @ 1,500 ppm | 2.5 MT / Day |
FLOQUIP™ PIU 300 | Pilot, medium injection rates | 30,000 bpd @ 1,500 ppm | 7.5 MT / Day |
FLOQUIP™ PIU 600 | Pilot, large injection rates, partial, full-field | 60,000 bpd @ 1,500 ppm | 15 MT / Day |
PIU INJECTION CONFIGURATION
There are different possible options for polymer flooding depending on site configuration.
Dilution with water can be done at low or high pressure.
VPR and LPR enable controlled injection in each individual well without degrading the polymer.
IF HIGH PRESSURE WATER IS AVAILABLE